Step 1: Supplies

The supplies you will need is the rainbow loom making kit, you will need to have some elastics.

Step 2: Placing the Bands

You start by taking your bolder color, an put it around one side of the board.

Step 3: Placing the Bands

You continue to place the bands up the side of the board.

Step 4: Placing the Bands

Once you have done the one side it should look like this.

Step 5: Placing the Bands

You should start to go to the other side an do the same thing as the other side.

Step 6: Placing the Bands

When all of the borders are done, it should look like this.

Step 7: Placing the Bands

Now that the border is done,you start on the "stars" by making them counter clockwise.

Step 8: Placing the Bands

You should be doing the stars like this.

Step 9: Placing the Bands

Once you finish the first star, you have to keep going up the board making more stars.

Step 10: Placing the Bands

In the end, it should look like this.

Step 11: Placing the Cap Bands

You should start placing the cap bands. You can do this by making a figure eight and folding it in half so it looks like two elastics on one peg.

Step 12: Placing the Cap Bands

You put the cap bands in the middle of each star. Put them all the way up the board.

Step 13: Looping the Bands

You have to flip over your board because now it is time to loop.

Step 14: Looping the Bands

You star by taking the first band and being it into the middle of the star.

Step 15: Looping the Bands

From here on, you take the middle of the star and put the elastic back onto the outside.

Step 16: Looping the Bands

After one star, the board should have one complete star. The rest of the stars will look like this,but in different colors.

Step 17: Looping the Bands

After the end of every star, you have to connect it to the next star above it. It should look like this when you connect it.

Step 18: Looping the Bands

It should look like this,but this is only two stars the whole bored should look like this when it's done.

Step 19: Looping the Bands

When it is all finished it should look like this.

Step 20: Looping the Borders

Now you will start to loop the borders so the whole bracelet will stay together.

Step 21: Looping the Borders

You will loop the bands up the sides like that

Step 22: Looping the Bands

This is what it should look like if you had done the borders and all the other steps.

Step 23: Taking Off the Bracelet

You should take one elastic and take you pen too and stick the pen in a peg so you can put the elastic there,so it can keep the bracelet to stay together.

Step 24: Fishing the Bracelet