Recast Chandilier

Introduction: Recast Chandilier

Four out of 10 lights remained after a catastrophic fall after the lights were hung. I made a mold out of one of them using Smooth On Mold Max and then cast the light with a mixture of Smooth On Crystal Clear and pigments. The box is just stained plywood and the cables and wiring had to be reworked, but were basically the same materials that came with the light. The hardest part was learning that large cones don't like coming out of a single mold. I should have built a better mold box and slit the mold vertically, but I was concerned about there being an ugly seam. It was messy and very time consuming, but the mold process was no different than anything else. The paper balls were my beautiful daughter's idea.

Make It Glow

Participated in the
Make It Glow

Instructables Design Competition

Participated in the
Instructables Design Competition

Reuse Contest

Participated in the
Reuse Contest

Be the First to Share

    Recommendations

    • Science Fair Challenge

      Science Fair Challenge
    • Origami Speed Challenge

      Origami Speed Challenge
    • Make It Modular: Student Design Challenge

      Make It Modular: Student Design Challenge

    Comments