Relay Motor Driver

Introduction: Relay Motor Driver

About: Hi, I am bharat .

HI TODAY I WILL SHOW YOU HOW I MADE A RELAY BASED H BRIDGE MOTOR DRIVER THAT I USED IN MY EDGE AVOIDING ROBOT AND OBSTACLE AVOIDING ROBOT.
PARTS YOU NEED
1. RELAY SWITCH
2. TRANSISTOR BC547
3. DIODE. IN4007
4. RESISTOR 1K
5. LED
6. PCB

Step 1:

YOU CAN USE L293D MODULE IN THESE ROBOTS BUT IT WORKS PROPERLY AT 9V.I AM GOING TO MAKE ONE

CHANNEL THAT INCLUDE TWO RELAYS AND TWO TRANSISTORS

HERE YOU CAN SEE IN ALL CONNECTION THE DIAGRAM.ONE IMPORTANT THING I DIDNT INCLUDE IN THIS VIDEO IS A FLYBACK DIODE WHICH NEED TO BE CONNECTED BETWEEN RELAYS INDUCTOR/COIL.

Step 2:

YOU CAN SEE IN VIDEO IF I GIVE A POSITIVE SUPPLY TO ONE LED THEN MOTOR TURNS CLOCKWISE

AND IF I GIVE THAT SUPPLY TO OTHER LED MOTOR TURNS ANTICLOCKWISE

Thanks

My twitter @ibharatmohanty

My YouTube Bharatmohanty

Be the First to Share

    Recommendations

    • Make it Move Challenge

      Make it Move Challenge
    • Space Contest

      Space Contest
    • Micro:bit Contest

      Micro:bit Contest

    Comments