Rocking Unicorn Resin Button

Introduction: Rocking Unicorn Resin Button

first video and first botton resin piece no one did only me ..lol...hope this help you guys>enjoy

Be the First to Share

    Recommendations

    • Summer Fun: Student Design Challenge

      Summer Fun: Student Design Challenge
    • Fandom Contest

      Fandom Contest
    • DIY Summer Camp Contest

      DIY Summer Camp Contest

    5 Comments

    0
    Fuzzy Monkey
    Fuzzy Monkey

    5 years ago

    Cool! would soldering the back on instead of using hot glue work? Thanks for the cool tutorial!

    0
    psychomiriam
    psychomiriam

    Reply 5 years ago

    soldering the back of the button well work as long your cover the holes and test run by using water to see there no water coming tought the back and then you be good for your resin work ... only diffenet i can only use touch the back with metal lol ....

    0
    psychomiriam
    psychomiriam

    Reply 5 years ago

    I all must forgot make sure u have the in button pin puch down so you do the resin your sticker dose not look puching up away from the button ,,you want the sticker flat and dont alot of resin for the cover it well flow over do a little a time and ben down to see if you miss spots ..and thank you have a other one button video as well.. have a nice day

    0
    Fuzzy Monkey
    Fuzzy Monkey

    5 years ago

    Cool! would soldering the back on instead of using hot glue work? Thanks for the cool tutorial!

    0
    Fuzzy Monkey
    Fuzzy Monkey

    5 years ago

    Cool! would soldering the back on instead of using hot glue work? Thanks for the cool tutorial!