Introduction: San Francisco Bay Bridge K'NEX Model
The Bay Bridge, was built in San Francisco over the San Francisco Bay. Also, this bridge was built to with stand an earthquake. In this intractable, I will show you how to make a model of the bridge out of K'NEX.
Step 1: Upper/Lower Deck
What you need:
4 Purple connectors
4 Orange Connectors
24 Red connectors
4 Green Connectors
14 Yellow Connectors
9 White Connectors
12 Grey Clamping Connectors
5 Blue Clamping Connectors
---------------------------------------------------------------
35 Green Rods
45 White Rods
8 Blue Rods
3 Yellow Rods
8 Red Rods
===================================
Now all you need to do is take the pieces listed and use the pictures to guide you through the building process.
DO STEP TWICE
4 Purple connectors
4 Orange Connectors
24 Red connectors
4 Green Connectors
14 Yellow Connectors
9 White Connectors
12 Grey Clamping Connectors
5 Blue Clamping Connectors
---------------------------------------------------------------
35 Green Rods
45 White Rods
8 Blue Rods
3 Yellow Rods
8 Red Rods
===================================
Now all you need to do is take the pieces listed and use the pictures to guide you through the building process.
DO STEP TWICE
Step 2: Bridge Tower
What you need:
2 Red Connectors
4 Green Connectors
4 White Connectors
2 Blue Clamping Connectors
2 Grey Clamping Connectors
---------------------------------------------------------------
6 Green Rods
4 White Rods
2 Blue Rods
3 Yellow Rods
2 Bendable Orange Rods
10 Red Rods(Orange Rods)
===================================
Now all you need to do is take the listed pieces and use the given pictures to build the tower of the bridge. Then connect the tower to the deck.
DO STEP TWICE
2 Red Connectors
4 Green Connectors
4 White Connectors
2 Blue Clamping Connectors
2 Grey Clamping Connectors
---------------------------------------------------------------
6 Green Rods
4 White Rods
2 Blue Rods
3 Yellow Rods
2 Bendable Orange Rods
10 Red Rods(Orange Rods)
===================================
Now all you need to do is take the listed pieces and use the given pictures to build the tower of the bridge. Then connect the tower to the deck.
DO STEP TWICE
Step 3: Hinge Pipe Beam
What you need:
8 Purple Connectors
12 Grey Connectors
4 Grey Rods
=================================== Now all You have to do is follow the pictures above to Build the beam.
Put the Grey Rods on the two sides of the bridge to connect them.
8 Purple Connectors
12 Grey Connectors
4 Grey Rods
=================================== Now all You have to do is follow the pictures above to Build the beam.
Put the Grey Rods on the two sides of the bridge to connect them.
Step 4: Your Done
Enjoy