Introduction: Santa Ornament

I am a 7th grade student at Eagle Hill middle school. This is the ornament I created for my Technology class. A little bushy bearded Santa Claus.

Step 1: Create Artwork

I hand drew this picture on paper, then put it into Autodesk Inventor and traced out the Santa Claus. I then extruded each part of the Santa Ornament so that certain parts would be raised higher than others.

Step 2: Scale the Drawing Down

I drew this ornament too large. The x dimension needs to be 2.11mm, y dimension needs to be 2.75mm and the z dimension needs to be set to 7.0mm.

Attachments

3D Printed Ornament Design Challenge

Participated in the
3D Printed Ornament Design Challenge