Screen Printing Washout Booth & Filter System

The photo above is my initial design for the filtration system.

Step 1: Materials

Step 2: Drain Basin

Step 3: Install Sump Pump and 1-1/4 in Connectors

Step 4: Connect Your Filter Housings

Participated in the
Build a Tool Contest 2017

Be the First to Share

Recommendations

Fused Glass IKEA Lantern Hack by sharonwarren in Art

3 1.0K

Chain Chomp Wall Lamp by aweirdguy in Video Games

149 11K

Copper and Steel Viking Helmet by joleothetall in Metalworking

99 8.8K

Damascus Steel and Silver Spinner Ring by ZebranoWoodCraft in Jewelry

74 6.1K

Rice & Grains Challenge
CNC and 3D Printing Contest
Puzzles Challenge

3 Comments

VictoriaH56

Question 4 years ago on Step 3

Where are the pictures ?

LargeWu

Question 4 years ago on Introduction

Thanks for the schematic. I built something kind of similar based on your post. I do have a question about how you handle waste water though. I find that when I either clean out ink or emulsion that the ink/emulsion gets suspended in the water, and neither settles out (in any reasonable amount of time) nor gets filtered by my canister filters (30 and 5 micron). The water coming out of my final filter is strongly tinted of the ink or emulsion. Have you noticed this problem, and if so, how have you handled it?

Swansong

5 years ago

That's a neat setup :)

Introduction: Screen Printing Washout Booth & Filter System