Set Up a Fastfold Projection Screen

Introduction: Set Up a Fastfold Projection Screen

The following will teach you how to set up a 7 1/2 x 10 Fastfold projection screen.

Step 1:

Remove contents from box.

Step 2:

Unfold screen frame and legs face down.

Step 3:

Lock frame and legs into position by sliding all clasps over all pegs. Extend corners of screen frame out into locking position.

Step 4:

Attach legs to screen frame by matching tape on legs to tape on frame.

Step 5:

Attach legs with cranks through the holes on screen legs and frame.

Step 6:

Remove screen from bag and flip frame face up.

Step 7:

Unfold screen and spread it over frame. Attach snaps on screen to corresponding grommets on frame. Make sure the skirt grommets on the screen are in position at the bottom of the frame.

Step 8:

Fully extend and lock top feet and tilt frame into a standing position. Then fully extend and lock back feet.

Step 9:

Attach skirt snaps to grommets at the bottom of the screen.

Be the First to Share

    Recommendations

    • Tinkercad to Fusion 360 Challenge

      Tinkercad to Fusion 360 Challenge
    • Home and Garden Contest

      Home and Garden Contest
    • Electronics Contest

      Electronics Contest

    Comments

    0
    DIY Hacks and How Tos

    Great tutorial. If only the manufacturer's manual was this well written.