Shaving Blade Microphone

Introduction: Shaving Blade Microphone

This is to demonstrate as to how the "GRAPHITE" inside a pencil could be used as a "TRANSDUCER" , to convert sound vibrations to electrical signal. This assembly of the double ended pencil suspended on two shaving razor blades picks-up the sound vibrations in close proximity. Affected by vibrations, the 'Graphite" in the pencil acts as a Variable Resistor in the electrical circuit of the Microphone in-put of the sound card of Computer. By adjusting the microphone input level to the sound card , good quality audio could be recorded.I have used "Audacity" audio recording software on my Ubuntu 16.04 Personal Computer.

2. In this project I have attached two razor blades on cardboard box using electrical insulation tape. Blades can also be fitted on a wooden block using screws.

Step 1:

Step 2:

Step 3:

Step 4:

Be the First to Share

    Recommendations

    • Made with Math Contest

      Made with Math Contest
    • Unusual Uses Contest

      Unusual Uses Contest
    • Hour of Code Speed Challenge

      Hour of Code Speed Challenge

    2 Comments

    0
    seamster
    seamster

    3 years ago

    Simple, but interesting project.

    0
    danjunk-DIY
    danjunk-DIY

    Reply 3 years ago

    Thanks Seamster ! For your kind appreciation.

    In fact a couple of times in the past, I used this assembly as an Earthquake detector-sensor.