Introduction: Simple Dual Monitor Stand!
More by the author:
About: My name is Hiyadudez. I make stuff. "The greatest barrier to success is the fear of failure."
This is basically what the title says. Its a stand that I created to support my dual 22" monitors and keep them raised off my desk. My main reason for creating this stand was because I do a lot of drawing and designing and my desk is the place I like to do it at, however my desk isnt very deep so I wanted to make something so my keyboard, mouse and xBox can basically 'hide away'.
When my screens are put horizontal to each other, they measure 110cm long, and my speakers were 10cm each, therefore I made my stand 125cm long, to allow the screens to be put side by side, while allowing enough room for my speakers to sit nicely on either side. The wood used was recycled from an old cupboard door (chipboard) so I put and extra leg in the middle for support as it wasnt the strongest material. The height, about 4", was determined so I could put my xbox beneath it while still giving it a good flow of air the reduce the overheating problems.
When my screens are put horizontal to each other, they measure 110cm long, and my speakers were 10cm each, therefore I made my stand 125cm long, to allow the screens to be put side by side, while allowing enough room for my speakers to sit nicely on either side. The wood used was recycled from an old cupboard door (chipboard) so I put and extra leg in the middle for support as it wasnt the strongest material. The height, about 4", was determined so I could put my xbox beneath it while still giving it a good flow of air the reduce the overheating problems.
Participated in the
Epilog Challenge V
Participated in the
Instructables Green Design Contest
