Simple K'NEX Gun

By in LivingLEGO & K'NEX

463

2

Introduction: Simple K'NEX Gun

By
About: Studying Electrical Engineering at Iowa State University.

Very Simple K'NEX Gun. Something fun to shoot with. Caution: not responsible for any injuries or damages caused by building or shooting of this gun.

Step 1: Assembly

Self Explanatory.

Step 2: Assembly Cont.

Use a knife/scissors or pull a rubber band apart till it breaks. Don't poke your eye out!

Step 3: Assembly Cont.

Take one end of the broken rubber band, and stick it in between the rod and the two connectors. You'll probably have to take a rod or two off to get the rubber band in place. Don't forget to put the "firing mechanism" on the rubber band too.

Step 4: Finished!

Pull the "firing mechanism" back. Put the holder down. Load ammo and fire. Have fun!

Be the First to Share

    Recommendations

    World's Fastest Can Opener
    World's Fastest Can Opener by sirjason132 in Kitchen
    1 281
    Cryptex - 10 Steps for 110 Possibles Designs
    Cryptex - 10 Steps for 110 Possibles Designs by Tony Vanpoucke in Toys & Games
    166 12K
    3D Printed Futuristic Space Age Wall Clock
    3D Printed Futuristic Space Age Wall Clock by kura_kura in 3D Printing
    56 3.4K
    Easy DIY James Webb Telescope Mirror.
    Easy DIY James Webb Telescope Mirror. by backwards lamb in Decorating
    1 151 12K

    • Make It Bridge

      Make It Bridge

    • Big and Small Contest

      Big and Small Contest

    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge

    2 Comments

    0
    BioSteam
    BioSteam

    9 years ago

    You can, but then how would you shoot if the rubber band is blocking the hole where the rod is suppose to be?

    0
    sandroknexmaster
    sandroknexmaster

    9 years ago on Introduction

    Why did you cut the rubber band? You can just wrap it around one of the yellow connetors.