Knex Scope

Introduction: Knex Scope

About: Hello, I am Dashadower, thank you for taking time to read this. I have started doing programming with python 5 years ago, when I was 11. Now, I write 3-dimensional games, and make developer apis. I will be hap…

This is my first of my knex gun accetories and my first instructables. It is a knex assault sight and is not meant for sniping. Fortunatly, there is less than 50 pieces. So I'll say that it is for beginers. It has two fastenars for rods or connectors.It is pretty simple to make.
Pic 1 the sight whit the connector fastenor.
Pic 2 the sight with the rod fastenor.
(Sorry for the spelling)

Step 1: The Parts

Yes, I did make the parts little.

Connectors:
White full moon: 15
Orange: 2
Grey one pronged: 5

Rods:
White: 4
Red: 1
Green: 1

Other:
Y clips: 4

Step 2: The Base

This is the base

1. What you will make
2. Make those two thingies
3. Make that
4.Put it together (please note the directions of the thingies)
5. Not on the picture but add the white rods to the end of the tow orange connectors.


Step 3: The Looking Piece

The looking piece

1. What you will make
2. Make that
3. Add that
4. Put those Y clips on.
5. Connect the base to the looking piece(note the directions)

Step 4: Finish

Yay! You're done!
If there is problems or you're stuck, please PM me.
Thanks

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • Anything Goes Contest

      Anything Goes Contest

    7 Discussions

    0
    morrisme
    morrisme

    Reply 6 years ago on Introduction

    it was good, but the scope was of low quality. try some more elaborate designs.

    0
    KnexFreak360
    KnexFreak360

    9 years ago on Introduction

    Done too many times, not a scope, and get your spelling right they have spell check for a reason!

    0
    DJ Radio
    DJ Radio

    9 years ago on Introduction

    Although that is a good way to attach a scope to a gun, scopes are not worth their own instructable.

    0
    Dashadower
    Dashadower

    Reply 9 years ago on Introduction

    Oh, but this is my first time posting so give me a chance