Simple Nerf Magstrike Magazine Mods.

Introduction: Simple Nerf Magstrike Magazine Mods.


In this Instructable, I am going to show you a few easy modifications for the Nerf Magstrike magazines. There are only a few supplies needed, and you don't even need to open up your gun!


Step 1: Increasing the Magstrike's Range!


Want to give your Magstrike a few extra feet of range? No problem! All you have to do for this part is take out the cross-shaped plastic air restrictors from the back of the magazine. Do this by placing your screwdriver in the center of an air restrictor, and hitting it with a hammer. Watch your fingers!


Step 2: Reliable Burst Fire!


There are some times in a Nerf fight when you just don't need to use a full magazine. Unfortunatley, the magazine drops back down into the gun when you let go of the trigger, making this very hard to do. Let's fix that! All you need to do is put 3-4 layers of duct tape on the right side of the magazine. After doing this your magazines should stay in place after firing in bursts! If your magazines still drop, simply add more layers of tape.


Step 3: Done!


Have fun with your improved Magstrike magazines!


Be the First to Share

    Recommendations

    • One Board Contest

      One Board Contest
    • Fix It Speed Challenge

      Fix It Speed Challenge
    • Raspberry Pi Contest

      Raspberry Pi Contest

    2 Comments

    0
    JamesL114
    JamesL114

    6 years ago

    I heard this mod, at most, increases the range by 2-3 ft, 10% improvement, I also heard this is also a placebo affect because the range's vary greatly.

    0
    BuzzSkull32
    BuzzSkull32

    11 years ago on Introduction

    O My God! it is so easy and it works like you would not belive.