Introduction: Simple Tilting Router Table Insert / Table Saw Extension
A simple tilting router insert, which fits into the extension table of my table saw.
Simple Tilting Router Table Insert / Table Saw Extension
7,305
80
5
7,305
80
5
A simple tilting router insert, which fits into the extension table of my table saw.
5 Comments
9 years ago on Introduction
Just making my router table right now. In the corners you added the screws to adjust the height of the plate? If yes. What I did, just made the hole thirst. After that putted two acrylic plates near each other and pressed the router (with the bit) between them until it touched the table. Then I did the landing for a plate. Worked like magic.
Now, where did you get the tilting mechanism? How do you work with that? How do you lifting the router? Will this tilting device work with MasterCraft router?
9 years ago on Introduction
I always enjoy watching your videos, they are clear, and clever.
Thank you!
Reply 9 years ago on Introduction
You should hear my wise cracks!
9 years ago
You do some really good work, my friend. I always enjoy your videos.
Reply 9 years ago on Introduction
Many thanks!