Simple Toothpaste Dispenser




Introduction: Simple Toothpaste Dispenser

 Have you ever thought about how it's discusting to share toothpaste with your family? There are so many germs involved in that process! Or Have you ever been frustrated while trying to squeeze out the last bit of toothpaste? If yes then build on  Well in this instructable i'm gonna show you a solution on how to avoid these obstacles. 

What you do is you put your toothbrush under this dispenser then push the button to get toothpaste.


Step 1: Gather Tools and Materials

 Materials needed:

-hard plastic cup

-spring from pen

-top of soap dispenser

-pieces of plastic

-Silver spray paint

-3-4 inch long nail

Tools needed:


-hot glue gun

Step 2: Hot Glue Plastic to Inside of Cup

 With scissors cut two pieces of hard plastic and glue on opposite sides to inside of cup. Make sure that it is big enough for a toothpaste tube could fit in it.  Now time to get ready for the next step!

Step 3: Make the Spring Mechanism

 This part may be a little confusing but thats why I have pictures. First put a hole in the bottom of the cup centered. Next put a hole in the side centered anywhere you want the dispenser. Now with a nail around 3-4 inches long  glue the sharp end to the soap dispenser end. Next slip spring over nail and make it so it stops where the nail and dispenser meet. Glue the end of the spring to the dispenser. Now with hard plastic cut out a washer shaped shape and slip it on the other side of the spring. Now put it all in the hole and Glue washer shape to outside of cup. Now test it out.

Step 4: Spray Paint It Silver

 Spray paint this now so it is all silver.

Step 5: Mount It and Add Toothpaste

 You can now put a tube of toothpaste in and make adjustments if needed. Good luck with this new instructable! You may even mount it by your toothbrush!

Humana Health by Design Contest

Participated in the
Humana Health by Design Contest

Be the First to Share


    • Holiday Decorations Speed Challenge

      Holiday Decorations Speed Challenge
    • Plywood Challenge

      Plywood Challenge
    • Battery Powered Contest

      Battery Powered Contest

    4 Discussions

    Kanein Encanto

    So the way this is working is you press the soap dispenser top and it pushes on a small spot on the tube every time? I have to say if that's the case, this'll work for a couple presses and then stop as the tube doesn't spring back, nor does most toothpaste flow.

    Or am I'm missing something in the construction yet?


    Reply 10 years ago on Introduction

     your missing something


    Reply 10 years ago on Introduction

     You don't even have any pictures of the toothpaste on the brush?