Speaker Box Design / Nautilus Shell

Introduction: Speaker Box Design / Nautilus Shell

About: Carpenter and Joiner

a while ago i drew this up in cad , it took a huge amount of time , 
its a speaker box in the shape of a nautilus shell ,

i played around with the design abit and was going to CNC 18mm MDF sheets , and restack the sheets back together with glue to form a nautilus shaped void in a solid rectangle block 

the cad files are of the " external " shape , where the nautilus shape is seen from the out side 
cheers , Ken Van Laatum

3D Design Contest

Participated in the
3D Design Contest

Be the First to Share

    Recommendations

    • The 1000th Contest

      The 1000th Contest
    • Battery Powered Contest

      Battery Powered Contest
    • Hand Tools Only Challenge

      Hand Tools Only Challenge

    3 Discussions

    0
    framistan
    framistan

    8 years ago on Introduction

    I once took a nautilus shell and placed a condenser microphone element at the center of the shell.(just dremmel a hole and glue it down). I thought it would make an extra good microphone. I glued it down with hot glue and it only took about 20 minutes to complete. However the sound was not good. The audio sounded hollow. Maybe it will work better making a speaker? It is amazing how nature produces this shape with so little effort isn't it?

    0
    AussieCFviolin
    AussieCFviolin

    Reply 8 years ago on Introduction

    its the way that the sound reflects off the inside's of the shell shape , its suppose to minimize the sound waves reflecting back to the back of the speaker ,