Star Shaped LED Jewelry




Introduction: Star Shaped LED Jewelry

About: I am IT professional, living in Bangalore, India. As new gadgets come out everyday, we indulge in spending significant time and money on these gadgets. And our kids are learning from us, they know how to use a…

Hi All,

Few months back I came across an instructable by jiripraus

I wanted to try the making one, for my wife and she wanted a Star shaped LED jewelry. I did a google and could not find any template for it. So I decided to make one myself

In this instructable I will share how to design and make your own led jewelry

Step 1: What Do We Need ?

  • Brass wire 21 Gauge ( approx 0.9mm)
  • LED Strips ( white ) or smd LEDs
  • CR-2032 battery
  • Soldering iron
  • Paper tape
  • one A4 Sheet
  • Pencil, compass, and a measuring scale
  • Cutter
  • Pliers Small
  • Multi-meter

Step 2: SMD LED

  • I extracted my LEDs from an old LED strip
  • These were white SMD LED
  • Approx 3 mm X 2 mm X 1.5 mm ( L x W X H )
  • Had a T sign on it which indicated the cathode for the LED
  • Carefully de-solder these leds from the strip
  • I needed 6, but i extracted 9 of these, just to be sure that I had enough to work with
  • Test the LEDs to make sure they are still working, replacing LEDs later is bit difficult

Step 3: Design Principles

  • The jewelry has to be as compact as possible, we need to use the smallest battery avaliable
  • We are not building a torch, do not use extremely bright LEDs
  • Joints should not have sharp edges
  • It should look simple and elegant
  • Measure the battery, LEDs and wire
  • My Battery was 20 mm in diameter
  • The star is made with a circle with 40 mm diameter, one could chose to make it more bigger depends on one's preferences

Step 4: Star Outline

  • Trace the outline with brass wire
  • To get better star shape we have to cut the brass wire as shown and then soldered the joints
  • Stick the wire in place using paper tape
  • Remember to file the joints, so that there are no sharp edges

Step 5: Add LEDs

  • The Star outline will be connected to positive end of the battery
  • So solder anodes of all 6 LEDS to the star as shown
  • Add joints to connect all cathodes of 6 LEDs as shown

Step 6: Add Hook

  • Since this is a going to be a pendant, We need a hook
  • Twist and cut a small hook of brass wire
  • Solder it flat to the star

Step 7: Battery Support

  • On the back , we will add two battery supports to hold the CR 2032 battery in place
  • one of the support is as the diameter and another at the bottom

Step 8: Finishing

  • Inspect the LED jewelry for week joints and add soldering where needed
  • Remember to file the joints, so that there are no sharp edges
  • Insert the battery and test all LEDs
  • Hook it in a chain and we are done

I hope this instructable will inspire you to design your own shape and make one

thanks for reading

Reuse Contest

Participated in the
Reuse Contest

Be the First to Share


    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • PCB Challenge

      PCB Challenge

    4 Discussions


    Reply 10 months ago



    1 year ago

    i really like the way you did the battery holder. Jiri sent me the templates via e-mail, so you just had to ask him. However, i really like this instructable as well


    Reply 1 year ago

    Thanks. I will also ask him