Steve Jobs Tribute Pumpkin

This pumpkin is carved using the iconic photo of Steve Jobs. Contrast was introduced to the photo digitally and then I carved it using pumpkin carving tools and a sewing needle for smaller holes. It took me about 2 hours of mapping out the image on the pumpkin and deciding what to carve out, and then around 3 and a half hours of actually carving. I've also included a pic of what it looks like without the backlight. Thanks for your kind consideration!

Participated in the
Halloween Decorations Challenge

Be the First to Share

Recommendations

AutoCAD MacroMitt by Wingletang in Arduino

46 3.0K

Ultrasonic Levitator by aanvi50 in Arduino

99 8.6K

DIY Solar Bottle Lamp - V2.0 by opengreenenergy in LEDs

136 19K

BCD Watch (Binary to Decimal) by vishalsoniindia in Arduino

28 8.5K

Electronics Contest
Make It Modular: Student Design Challenge
Chocolate Challenge

4 Comments

sradia

8 years ago on Introduction

Wait a sec.... That picture of the pumpkin up there is what it look like without light? That's the finished product...without light? That's absolutely insane! I can't even fathom how talented you are to be able to see this vision. Damn amazing