Stick-on Duct Tape Guitar Pick Holder
Intro: Stick-on Duct Tape Guitar Pick Holder
Ever wanted to have your picks with you? ON your guitar? Then why don't you try this super cheap, somewhat durable, doesn't leave permanent marks on your guitar, kinda crappy guitar pick holder?
You need:
duct tape
picks
scissors/knife
guitar
You need:
duct tape
picks
scissors/knife
guitar
STEP 1: Start
Roll out and cut about 4 inches of duct tape.
STEP 2: Cut in Half
Cut the four inch piece into two pieces long ways.
STEP 3: Begin Assembly
Take one of the strips and wrap a straight ring around one guitar pick. Don't make it to tight though, so you have room for more picks.
STEP 4: Indent.
Indent the two sides where the pick starts to narrow.
STEP 5: Start Covering
Cut off a small piece of the next strip and cover the bottom with it (Sticky side out)
STEP 6: Keep Going.
Cut another small piece off and cover the bottom (sticky side in).
STEP 7: Almost Done.
Cover up the rest of the case and cut off any excess hanging off the top.
STEP 8: Cut
Cut a notch in the front for access to the picks.
STEP 9: Last Step
Cut a small strip and wrap in a circle (sticky side out). stick this on the back of the case and onto your guitar.
Done.
Done.
27 Comments
patricjh 10 years ago
Undermig 15 years ago
muffinhead 15 years ago
freeza36 12 years ago
Undermig 15 years ago
rkpia 12 years ago
that clips to your strap. I call it a Pic Stik check it out www.stickyourpick.com
monkeyman26 13 years ago
sailorjosh123 14 years ago
rtmciv 14 years ago
redsoxdrummer 14 years ago
muffinhead 14 years ago
NeonLime 16 years ago
LargePaperCup 14 years ago
GorillazMiko 16 years ago
LargePaperCup 14 years ago
muffinhead 15 years ago
randomrocks=D 15 years ago
Brother_D 15 years ago
mrjubjub 15 years ago
ConcorX 16 years ago