Introduction: Materials
Soda Can
Packing Tape
Fishing Line
Step 1: Line
Get about 12 feet of line
Step 2: Putting the Line on the Can
Tie the line on the tab of the can. I used a clinch knot
Step 3: Keeping It From Getting Tangled
Put a piece of packing tape on the can to keep it from getting tangled.
Step 4: Wrap It Up!
Wrap the line around the can leaving some room for tackle
Step 5: Put Tackle On
Put your tackle on and start casting! If you are confused on how to cast, Think of it like a spinning reel. Hold the can, while casting like a regular rod
2 Comments
7 years ago on Introduction
Nice design! Thanks for sharing!
7 years ago
That's a good idea. My first question was "why not just use the line and tackle by itself? " but then realized that sometimes you might have to cast out a bit to get in a better fishing spot. I will have to remember this the next time I go fishing and screw up my reel.