Swiss Army Knife Case

1,906

26

2

Introduction: Swiss Army Knife Case

I'm looking to get into leatherworking, but to do that I need to learn how to sew. This project allowed me to practise my backstitch in some thicker material: leatherette!

Step 1: Cut the Material

I cut out my material to the rough sizes that I wanted. I cut two rectangles of the same shape, leaving them about 1cm wider than the edge of the knife.

Step 2: The Backstitch

The entire seam on this piece is a backstitch. This involves pushing the thread in, then up a specified distance. After that, thread the needle back through the whole you just created. Finally, advance double the distance, beginning a new hole, and then repeat the process all the way around.

Step 3: Inside Out

Turn the leatherette inside out, to reveal the colour and texture.

Step 4: Done!

With that, I have a nice little case for my Swiss Army Knife. I'm very happy with how it turned out and it was great practise!

Thank you for reading, and I hope you enjoyed!

-Shaun

Tandy Leather Contest 2016

Participated in the
Tandy Leather Contest 2016

Maker Olympics Contest 2016

Participated in the
Maker Olympics Contest 2016

Be the First to Share

    Recommendations

    • Pi Day Speed Challenge

      Pi Day Speed Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Sculpt & Carve Challenge

      Sculpt & Carve Challenge

    2 Comments

    0
    3366carlos
    3366carlos

    4 years ago

    very nice, the saddle stitch would be good too.

    0
    ShaunM11
    ShaunM11

    Reply 4 years ago

    Thank you!!