Introduction: Switching Using Transistor in Arduino Using TinkerCAD Circuits
This project illustrates the use of Transistor as a switch using TinkerCAD circuits
Step 1: Components Required
Arduino UNO (1 No.)
Breadboard (1 No.)
Resistor 1k ohm (2 No.)
LED (1 No.)
Transistor (1 No.)
Jumper wire (3 No.)
Step 2: Breadboard Diagram
Make connections as shown in the breadboard diagram
Step 3: Block Code
Step 4: Start Simulation
Click Start Simulation to see the action
Comments