TRIPWIRE ALARM USING OLD MOUSE

Introduction: TRIPWIRE ALARM USING OLD MOUSE

About: Hi, I am bharat .

hi in this series i am going to make some easy projects using computer mouse.this project is the second one in this series.in this project i will make a tripwire alarm system using old mouse.

first one is here

Step 1:

first of all open mouse

Step 2:

now you can see two switches here we need one of them.

Step 3:

after desoldering it i solder it with a battery and a buzzer in series. i checked it whether switch working or not.

Step 4:

to make trigger system i am using stapler pin and a thread...

Step 5:

to trigger it just pull the thread .subscribe my YouTube channel bharat mohanty for more project videos

thanks............

Be the First to Share

    Recommendations

    • Microcontroller Contest

      Microcontroller Contest
    • Crayons Challenge

      Crayons Challenge
    • Fandom Contest

      Fandom Contest

    4 Comments

    0
    ronanry
    ronanry

    Question 2 years ago

    how do you put the strapler ? even in the video it's not really visible .
    It could have been a good instructable with this information clearly displayed

    0
    BHARATMOHANTY
    BHARATMOHANTY

    Answer 2 years ago

    I bend it little bit so that it can hold and push the switch as you can clearly see in this video.it is the most simple instructable compare to my other projects...have a look on those projects too✌️

    0
    ronanry
    ronanry

    Reply 2 years ago

    ok, so now i understand how it does work ! in fact it's ALWAYS clicked and when the straple "is released" the switch ...switches (:p) ...thanks for the explanation