Introduction: The Kne'x Catapult
this is my knex catapult for the launch it competition when you first build it it needs some fine toning but it is a great catapult otherwise.
Step 1: Materials
1 grey rod
2 large wheels
6 blue rods
one very large rubberband
12 red rods
7 yellow rods
11 white rods
2 orange conectors
6 red connectors
8 purple connectors
8 blue connectors
8 green conectors
3 yellow connectors
6 white connectors
3 grey connectors
ammo
one small ruberband
one red conector
2 large wheels
6 blue rods
one very large rubberband
12 red rods
7 yellow rods
11 white rods
2 orange conectors
6 red connectors
8 purple connectors
8 blue connectors
8 green conectors
3 yellow connectors
6 white connectors
3 grey connectors
ammo
one small ruberband
one red conector
Step 2: The Lower Body
Step 3: Appendages
these are adjustable for the most part
Step 4: The Upper Body
after you are done with this part stack the two parts of the body
Step 5: Ammo
tie the small rubber band through the hole of the red connector and tie it around its self so that it may hook on