Introduction: The LEDPOD Dimmer
This is the dimmer I built and soldered on a blank proto-type PCB for my LEDPOD project (If you haven't seen it, You probably won't understand what this is for).
It works on: 3 resistor modes, Off,and On.
The switch you see in the second picture is from a fan I took apart.
The resistors I used:
- 10 ohm
- 27 ohm
- 80 ohm

Participated in the
Soldering Challenge

Participated in the
Photography Tips and Tricks Contest

Participated in the
Metal Contest
2 Comments
8 years ago
This has a way better chance of winning than my music pillow good luck
Reply 8 years ago
Thank You for your support!!
This actually isn't one of the projects I've made that I think will win...
But I don't know :)