Introduction: The Double Sided Modular Altoids Survival Tin
There are Tons of Altoids Survival tins on the Internet but; Mine is Double the Space and is FULLY Customizable ( I will add Velcro later and show you how to add add ons! )
Materials Needed:
2 Altoids Tins
Double Sided Sticky foam
Duck Tape
Scissors
Time to Assemble:
15 Minutes
Materials Needed:
2 Altoids Tins
Double Sided Sticky foam
Duck Tape
Scissors
Time to Assemble:
15 Minutes
Step 1: Set Up and Asembly
Place Tins upside down, I have them so the tin flaps will open from the same side. ( Pic 3 )
Press sticky tape on one side of a tin leaving one side of the tape with paper still attached so you wont get dirt or stuff on the foam. Overhang tape a little over edges of tins then trim off with a exacto knife or scissors.
( Pics 4&5)
Remove paper from sticky foam and press tins together. ( Pic 6 )
Line up Duct tape and score a line ( or use a ruler..LOL ) and tear at scoring then wrap tape around the tins a few times. ( Pic 7 )
Press sticky tape on one side of a tin leaving one side of the tape with paper still attached so you wont get dirt or stuff on the foam. Overhang tape a little over edges of tins then trim off with a exacto knife or scissors.
( Pics 4&5)
Remove paper from sticky foam and press tins together. ( Pic 6 )
Line up Duct tape and score a line ( or use a ruler..LOL ) and tear at scoring then wrap tape around the tins a few times. ( Pic 7 )
Step 2: Final Assembly
I Placed the sticky foam inside and put a few demo items inside tins and also cut a piece of the tape to hold the small items it.
Well; Thats it, I will post MORE pictures as this project is just getting started, it will have Velcro ALL around it and you will see more to come!!!
Enjoy
Dane
Well; Thats it, I will post MORE pictures as this project is just getting started, it will have Velcro ALL around it and you will see more to come!!!
Enjoy
Dane