The Spitball Sniper
Intro: The Spitball Sniper
Well I guess I'm back
this is one I had planned back for September
and I like how stable the base is so here you go
this is one I had planned back for September
and I like how stable the base is so here you go
STEP 1: Materials
So here you go
materials:
tape or hot glue
straws
Tools :
scissors
ruler
materials:
tape or hot glue
straws
Tools :
scissors
ruler
STEP 2: The Barrel
Tape or glue the two straws together as shown
STEP 3: The Sight
cut aproximatly an inch off of the third straw. Then cut 2 1/2 centimeter lengths to stand the scope. Glue or tape together as shown. Mount, then cut a small sliver bend it tape it under the scope to make a crosshair.
STEP 4: The Stand
cut two centimeter pieces at a diagonal and tape them on the front of the bottom barrel with the diagonal pointed so it lines up with the table as shown.
STEP 5: The Stock
cut one length one and tape it under the extra at the end of the gun.
And enjoy!
And enjoy!
13 Comments
Atlas Portal 2 12 years ago
DogDynamo13 12 years ago
Atlas Portal 2 12 years ago
spizman 12 years ago
DogDynamo13 12 years ago
DogDynamo13 12 years ago
Air_Assassin 12 years ago
DogDynamo13 12 years ago
Air_Assassin 12 years ago
ThaAWESOMEducttapeguy 12 years ago
DogDynamo13 12 years ago
AndyGadget 12 years ago
How do you look down the sight AND blow through the end both at once?
(Or am I missing something?)
DogDynamo13 12 years ago
thats why I made the stand