Introduction: The Extreme ShOcKeR!!!#%@&
More by the author:
About: Hello, do you like to shock, destroy, animate,play Minecraft, write code, learn simple life hacks or just have fun? Well you found the right place!
Hello, is your sister getting on your nerves? Is someone stealing at school or cheating on you? Well, worry no more! today we are going to make a extreme shocker that delivers enough voltage to really buzz um. I doubt after one shock they will come back!
Step 1: What Do You Want to Do This For?
Well how about at school a punk bully is picking on you. Or you need protected in a emergency. What if you have a robber break in? Well this project is right for you! Who needs to dial 911?(im not saying dont) Lets just take care of it ourselves! (Disclaimer)-//Im just giving a good intro, always dial 911 in emergencies. But do realize this is not a toy and can hurt you very bad.
Step 2: What You Need
Before you begin, you may want to see how dangerous it really is.
Here is a link to a video were I shock a few things!
http://www.youtube.com/watch?v=2F2eV6itIF4&feature=youtube_gdata_player
You will need a disposable camera
Tape
Hot glue
Solder
Soldering iron
Wires
AA batteries
AA holder (optional you can tape wires to the leads if you want)
A container (optional)
Tacs (optional)
Now i used screws instead of tacs, but with either you need to have a plastic container so You Dont Get Shocked!
Here is a link to a video were I shock a few things!
http://www.youtube.com/watch?v=2F2eV6itIF4&feature=youtube_gdata_player
You will need a disposable camera
Tape
Hot glue
Solder
Soldering iron
Wires
AA batteries
AA holder (optional you can tape wires to the leads if you want)
A container (optional)
Tacs (optional)
Now i used screws instead of tacs, but with either you need to have a plastic container so You Dont Get Shocked!
Step 3: Taking It Apart
Disasemble the camera and take the circuit board out.
Be careful there is 300V on that capacitor in the second picture.
Now carefully take a screw driver and touch the two leads with it and it will give quite a burst.
Be careful there is 300V on that capacitor in the second picture.
Now carefully take a screw driver and touch the two leads with it and it will give quite a burst.
Step 4: Connecting the Capacitor
Solder to of the switch wires to the two terminals that charge the circuit. Now solder or glue or splice wires to the capacitor leads and strip the ends.
Solder two wires to the AA holder that comes with it so it gets power easier.
put the AA in its holder, charge it up and test it!
Here is mine in action!
https://www.youtube.com/watch?v=2F2eV6itIF4&feature=youtube_gdata_player
Please subscribe to my new youtube channel i will be doing all kinds of tutorials there too!
Solder two wires to the AA holder that comes with it so it gets power easier.
put the AA in its holder, charge it up and test it!
Here is mine in action!
https://www.youtube.com/watch?v=2F2eV6itIF4&feature=youtube_gdata_player
Please subscribe to my new youtube channel i will be doing all kinds of tutorials there too!
Step 5: Finishing
Put it all safely in some container make sure its plastic so you dont get shocked though
Secure with glue and isolate,
Put tacs on the end and there you go!
im not responsible if you kill someone so dont blame me its your action
Secure with glue and isolate,
Put tacs on the end and there you go!
im not responsible if you kill someone so dont blame me its your action