Electromagnetic Inductor

Introduction: Electromagnetic Inductor

About: I am robotics engineer and a teacher whose passion in life is breaking down the maths and academic jargon of programming and robotics into something that everyone can understand, primary school kids included.…

To understand the theory of electromagnetic motors. watch opening 3 minutes of this video
Components Used:

C or D Battery (1pcs)

1m of solid core copper wire

Iron all thread M6 or larger.

Tools used:

Sandpaper sheet

Lighter

Pliers

Step 1: Wrap the Copper Wire Around the All-thread and Close Off the Ends With Insulation Tape

Step 2: Connect the Battery to the Ends of the Wire

Step 3: Test Out Your Inductor on a Compass and Some Nails

Your inductor should be a temporary magnet as long as the wire is connected to the battery.

Be the First to Share

    Recommendations

    • Anything Goes Contest 2021

      Anything Goes Contest 2021
    • Photography Challenge

      Photography Challenge
    • Raspberry Pi Contest

      Raspberry Pi Contest

    Comments

    0
    gearup500
    gearup500

    6 years ago

    I made one of these before. Here's the link

    https://www.instructables.com/id/High-Grade-Electromagnet/