Introduction: Transitions Using 7 Segment Display

About: pursuing Bachelors in Electronics and Communication at Chandigarh University

I already published a project on 7 segment display with Arduino click here to access that project. In this project, I have changed the code in order to do transitions on 7 segment display . It is a very satisfying and easy project to make . you must give it a try too.

Components required

  1. Arduino -
  2. 7 segment display -
  3. 8 x resistor 220 ohms -
  4. jumper wires -

Step 1: Circuit Schematic

Step 2: Arduino Code