Introduction: Travel Protector for Books
Hello! This will be my last instructable for 2 years, due to me serving a mission for my church. So this instructable is how to protect your book(s) from travel damage using 3d printed parts. When you travel your books are susceptible to being dropped, which causes the corners to fray, and the covers can rip and get worn down, lets fix that!!
Step 1: 3d Print the Corners
The only materials needed are eight rubber bands, some books and four 3d printed corners. the corners I uploaded are 60mm. So they can protect books up to 60mm thick. If any of you want me to upload any different sizes I can until February 2nd.
Attachments
Step 2: Connect the Corners
After I printed the corners I tied rubber bands in between them to make a loop. Than I loped the finished product over opposite corners of the book.
Step 3: And You're Done!
As you can see with both corners in place, The book protector can protect the book from fall damage, small spills and from getting your cover ripped up. I hope you enjoyed this!
Step 4: Extra Files
These are files that im uploading based upon request :)