Twine Tomato Holder

• All you need for this project is 3 T-Post,Twine,& a Knife It should take about 2 or 3 minutes for each Tomato Plant.

Step 1: Driving & Stringing the T- Post

• 1. Get your T-Post & Driver drive all of the T-Post in a strait line & Tie a line from T-Post to T-Post.

Step 2: Cutting & Tying the Twine

• 2. Cut your twine & tie a Figure 8.

Step 3: Draping & Attaching the Twine to the Tomato Plant

• .3 Drape Twine over Twine attached to T-post, then attach Figure 8 to Tomato Plant, last tie Half Hitch to Tomato Plant.

Step 4:

Comments

[DIY Hacks and How Tos]

Cool project. If you upload the video to a video sharing site like YouTube, you can embed the video in the step so that people can watching on the same page as your instructions without having to download it.

[ShadowRed]

THX for the tip!

[Lorrainecm5]

wish I knew where to buy the twine ):

[Chicken Charmer]

TSC or possibly at a art store

[freezerboy620]

You are mean. That was when i was new to instructables and you said it was stupid