USB Drive Butterfly Knife

by skaterqwertyuiop

8.0K204

Intro: USB Drive Butterfly Knife

 Do you want to show off your balisong tricks to your friends in school?
Are you looking for a cooler flash-drive?
FUNKYYYYYYYYY       TIMEEEEEEEEE!!!!!

4 Comments

Doomog 14 years ago

How did you form the platform for the pins AND make it stay to the naked chip?

skaterqwertyuiop 14 years ago

 I cut and drilled a piece of scrap metal. it looked like this- (o   o)
Before i glued it to the drive, i put a layer of glue down and waited for it to harden (so the metal would not connect the parts of the drive). Then I glued the metal piece onto the hardened glue.
I used a very powerful glue, I'll write the name later.