Venom Snake Automaton: [ 11. LEFT CAMS ASSEMBLY (G10) ]

Introduction: Venom Snake Automaton: [ 11. LEFT CAMS ASSEMBLY (G10) ]

About: Automata for 3D printing

Step 1: G10 Parts

Step 2: G10 Assembly (Part 1)

Step 3: G10 Assembly (Part 2)

Step 4: G10 Assembly (Part 3)

Step 5: Painting Guide

Step 6: G10 Assembly (Part 4)

WARNING: Be careful when turning the crank, it may get stuck because it is not fully constrained yet. If it gets stuck don't force it, align the misaligned parts, turn the crank ¼ of rotation the opposite direction, and try again.

<< 10. RIGHT SCISSORS ASSEMBLY (G9)
0. CONTENTS
>> 12. LEFT RAILS ASSEMBLY (G11)

Be the First to Share

    Recommendations

    • Make it Fly Challenge

      Make it Fly Challenge
    • DIY Summer Camp Contest

      DIY Summer Camp Contest
    • Metal Contest

      Metal Contest

    Comments