Venom Snake Automaton: [ 16. FEET, PLATFORM, AND BASE ASSEMBLY (G15 AND G16) ]

Introduction: Venom Snake Automaton: [ 16. FEET, PLATFORM, AND BASE ASSEMBLY (G15 AND G16) ]

About: Automata for 3D printing

Step 1: G15 Parts

Step 2: G15 Assembly (Part 1)

Step 3: G15 Assembly (Part 2)

Step 4: G15 Assembly (Part 3)

Step 5: G15 Assembly (Part 4)

Step 6: G15 Painting Guide

TIP: Use varnish to protect the paint of the platform and the boot's outsole.

Step 7: G15 Assembly (Part 5)

WARNING: Be careful when turning the crank, it may get stuck because it is not fully constrained yet. If it gets stuck don't force it, align the misaligned parts, turn the crank ¼ of rotation the opposite direction, and try again.

Step 8: G15 Assembly (Part 6)

Step 9: G16 Parts

Step 10: G16 Assembly (Part 1)

Step 11: G16 Painting Guide

TIP: Use varnish to protect the paint of the base.

Step 12: G16 Assembly (Part 2)

Please, use the base to hold the automaton while turning the crank.

Support me on Patreon so I can design more: www.patreon.com/soludus

Software used for the creation of the automaton:

  • Blender
  • Daz Studio
  • Fusion 360

Software used for the instructable:

  • Gimp
  • Google Docs
  • Grammarly
  • Inkscape
<< 15. FRONT MECHANICS ASSEMBLY (G14)
0. CONTENTS

Be the First to Share

    Recommendations

    • Micro:bit Contest

      Micro:bit Contest
    • First Time Author Contest

      First Time Author Contest
    • Lamps and Lighting Contest

      Lamps and Lighting Contest

    Comments