Very Simple Wind Turbine

2,449

34

1

Introduction: Very Simple Wind Turbine

Materials:
5v motor
led
plastic fan ~4" diameter
glue fan to motor shaft
hold led on motor leads (can also solder if desired)
apply wind/compressed air

I made it at TechShop
http://www.techshop.ws/

Be the First to Share

    Recommendations

    • Cookie Speed Challenge

      Cookie Speed Challenge
    • Reclaimed Materials Contest

      Reclaimed Materials Contest
    • 3D Printed Student Design Challenge

      3D Printed Student Design Challenge

    Comments

    0
    t0my
    t0my

    4 years ago

    Why doesn't my led light?

    I use a simple 5mm led, which is not burnt (tested with a cr2032 battery). Is it perhaps of low revs. I haven't manage to test it in high wind. Only by rotating the axle by hand.

    Thanks