Vibrobot

Introduction: Vibrobot

Step 1:

glue a popsicle stick down the middle of the altoids tin. Make sure a 9 volt battery can fit on both sides you might need something to hold the battery in place. then glue an engine on both sides of the altoids tin as seen in the picture. Cut holes in the top of the tin as seen in the picture.

The Mad Science Fair

Participated in the
The Mad Science Fair

Pocket-Sized Contest

Participated in the
Pocket-Sized Contest

Make It Stick Contest 2

Participated in the
Make It Stick Contest 2

Be the First to Share

    Recommendations

    • Go Big Challenge

      Go Big Challenge
    • Make It Modular: Student Design Challenge

      Make It Modular: Student Design Challenge
    • Electronics Contest

      Electronics Contest

    Comments