Vibrobot, the Easiest!

11K2010

Intro: Vibrobot, the Easiest!

This is an easy instuctable how to make a vibrobot out of a LED torch and a vibrator from a mobile phone!

STEP 1: The Vibrator!

First of all you need a vibrator. You can get one from your mobile phone. I used an old Sony Ericsson, but I did not have the right screwdriver so I just smashed it whit a hammer.

STEP 2: This Is the Vibrator!

What it looks licke?
That it looks licke!




STEP 3: The LED Torch...

I have got the mini LED torch from my bicucle, it is the light from the bag.
You shall remove the cap of it and then take the electro boad out.
Clip the LED of, close to the top of it...

STEP 4: Sold the Vibrator

When you have cut the LED of then on-solde the vibrator on the 2 wirers and put it all together again -The LED. (the vibrator vill fit in the same hole where the LED has been)

STEP 5: Finish!

Now you supose to have a Vibrobot!!!
Enjoy it spinning around your table.

PS. you can put a litle 3 V bateri on top of it to make it look cooler.

10 Comments

This is the best form of instructions ever!! THanks for the info and its really easy!!
Parts could be had from www.sciplus.com
battery used?
I believe he just kep the battery in there from the light
>.> you said sold not solder >.<
i used to have the same phone lol
this gave me a great idea get a maglite 2 cell aa and take out the bulb now open up your phone and get the motor solder 2 pins 1 for each side and plug in to mag lite it vibrates ooooooooo
It isn't in all phones, sometimes it's just a coil or so:(
Cool Instructable. I opened up my cell phone, no luck. Couldn't find a motor thing. That was a few weeks ago though. And by the way, you should spell check a little. I understood it all, but you should do it if there are some people out there that only had their brains to read perfect English. :P Pictures are okay too. Not the best, not the worst, but I could get the idea. Nice job!