Virtual Dice

By in CircuitsArduino

206

1

Introduction: Virtual Dice

The virtual dice is a project I came up with while experimenting with various Arduino ideas. It is very simple and anyone who can assemble a project can make this with my provided code. Enjoy!

Copyright (C) 2019 GreatMJH. All Rights Reserved. Available under CC-BY-SA license.

Step 1: Get the Parts

The following parts are required:

  • Arduino UNO (or any other Arduino board, but the diagram is for UNO)
  • 7x 240-ohm resistors
  • 1x Push button switch
  • 1x 1k resistor
  • 13x Jumper cables

These parts can all be found from any major electronics retailers.

Step 2: Build the Circuit!

Build the circuit as per the diagram on a breadboard.

All LEDs have negative on the left side and positive on the right side.

Step 3: Upload the Code

Once you have assembled the circuit, you can now upload the code to your Arduino.

Attachments

Step 4: Enjoy!

Thank you for following this Instructable. Please leave any suggestions in the comments and if I see them I will respond.

Be the First to Share

    Recommendations

    Rubik's Cube Solver
    Rubik's Cube Solver by aaedmusa in Gadgets
    141 21K
    Rock Paper Scissors Using Tinkercad Circuits and Arduino
    Rock Paper Scissors Using Tinkercad Circuits and Arduino by CrazyScience in Arduino
    1 78 10K
    Basics of Arduino (TINKERCAD)
    Basics of Arduino (TINKERCAD) by Mukesh_Sankhla in Grades 6-8
    233 16K
    Laser-Cut Infinity Dodecahedron (Fusion 360)
    Laser-Cut Infinity Dodecahedron (Fusion 360) by thomasj152 in LEDs
    185 16K

    • For the Home Contest

      For the Home Contest

    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge

    • Make It Bridge

      Make It Bridge

    Comments

    0
    Penolopy Bulnick
    Penolopy Bulnick

    4 years ago

    Looks like a fun project to make with Arduino :)