Whiskey Dispenser (Golf Cart)

Introduction: Whiskey Dispenser (Golf Cart)

Stripped down a couple of pumps and containers to make this for a buddy who loves golf..........and whiskey.

Step 1: Box

Built it out of 1/4" Baltic birch
Handles are maple
Spout is 1/2" stainless steel
Covered with carbon fibre

Step 2: Pump Assembly

Pump is located at the bottom, center.
Surgical hose runs through the stainless to about an 1" from the end.

Step 3: Free Standing

Step 4: Golf Cart Mode

Not shown is the center stub at the bottom of the box which fits in the center pocket on nearly any golf cart. The spouts line up with each cup holder.
3 golf tee holders and a cell phone pocket.

Be the First to Share

    Recommendations

    • Barbecue Speed Challenge

      Barbecue Speed Challenge
    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest
    • Arduino Contest

      Arduino Contest

    Comments