Wine Tray

Intro: Wine Tray

For this wine tray I used 2 MDF boards 50cm x 25cm – one for the base and one as a top shelf.
Aluminum pipe was sawed to 3 same parts - 15cm each one.
In a base plate I drilled 3 through holes and then hollows, about 5 mm depth.
On the next step I attached top board to the base in reason to drill 3 holes in exactly places for pipes.
I did one layer coating and after the drying is a last step – an assembly.
I used 3 screw rods and decorative nuts (M6).

So, if your friends invited you to BBQ - this tray can be a good present for them :)

Comments

[AnthonyC280]

Really nice design. Do you have a template for this build? Appreciate any details (dimensions) .

[craftclarity]

This is really nice.

[FS2010]

Thanks !

[BLR_RAVI]

wonderful..i like it

[FS2010]

Thanks :)

[FS2010]

Thank You !

[Penolopy Bulnick]

Great design :)

[FS2010]

Thanks :)