Introduction: Working With Seven Segment Display Using Arduino
This project demonstrates working with Seven Segment Display and Arduino in TinkerCAD circuits .
Step 1: Objective
To display digits 0 to 9 at a time interval of 1 sec.
Step 2: Components Required
Arduino UNO (1 No.)
Breadboard (1 No.)
Seven Segment Display (1 No.)
Resistor 1k ohm (8 No.)
Jumper wire (2 No.)
Step 3: Breadboard Diagram
Make the connections as shown in the figure above.
Step 4: Block Code
Step 5: Start Simulation
Click Start Simulation to see the action
Comments