Working With a LED and a Push Button Using Arduino in TinkerCAD

Introduction: Working With a LED and a Push Button Using Arduino in TinkerCAD

About: Mechanical Engineer

This project demonstrates working with a LED and a Push Button using Arduino in TinkerCAD circuits.

Step 1: Objective

  • Make the LED ON when the Push Button is Pressed.
  • Make the LED OFF when the Push Button is Pressed.

Step 2: Components Required

  • Arduino UNO (1 No.)
  • Breadboard (1 No.)
  • Resistor 1k ohm (2 No.)
  • LED (1 No.)
  • Push Button (1 No.)
  • Jumper wire (5 No.)

Step 3: Breadboard Diagram

Make the connections as shown in the figure above.

Step 4: Block Code: LED Turns ON When Push Button Is Pressed

Step 5: Block Code: LED Turns OFF When Push Button Is Pressed

Step 6: Start Simulation

Click Start Simulation to see the action

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • PCB Challenge

      PCB Challenge

    Discussions