Introduction: Base for Modular Origami
In this instructable, i'm gonna show you how to make the base for lots of modular origami.
Step 1:
start with a piece of origami paper.
Fold in half horizontal.
Fold in half again.
Step 2:
Fold the upper left corner and the lower right corner to meet the upper and bottom creases.
Fold along the creases to meet in the centre.
Fold the left corner up and the right corner down.
Tuck the corners into the pockets.
Step 3:
fold the flaps back
Assembly: look at the pictures.
Step 4: A Few Examples.
A few models you can make using this piece.
10 Comments
9 years ago on Introduction
Hi,
I want to try this.
They sell in my town origami paper 10x10 cm.
So I guess I could try to do 4 pieces of size 5x5cm each :)
10 years ago on Introduction
I agree, the tetris set is cool.
Reply 10 years ago on Introduction
Ditto! This looks fun and those tetris ones are awesome!
Reply 10 years ago on Introduction
thanks again :)
10 years ago on Introduction
Very nice, but What is the size of the square of paper ?
Reply 10 years ago on Introduction
thank you
in inches: 1,8
in centimeters: 4,75
Reply 10 years ago on Introduction
Thank's, good continuation.
Reply 10 years ago on Introduction
your welcome :)
10 years ago on Introduction
Very cool! I have to build a tetris set now!
Reply 10 years ago on Introduction
Thanks! :)