Introduction: Basic One Handed Sword
This is just a basic one handed sword I made myself.
Step 1: Pieces
you will need:
rods: blue-12 white-15 yellow-2 red-4 grey-1
connectors: 4 snowflakes 2 blue sliders 4 yellows 4 greens 1 red
others: 2 nine hole squares 4 three hole triangles
Step 2: Blade
I think this is the simplest part of the sword. Just follow picture.
Step 3: Handle
simple handle. grey piece will come into play later
Step 4: Support
this supports the blade so it doesn't spin. this is just my bottom for it.
Step 5: Connect Handle and Support
this is where the grey piece comes into play
Step 6: Connect It All
add the blade
18 Comments
11 years ago on Introduction
Nice. Now make a two handed version XD
14 years ago on Introduction
Looks more like a pooper-scooper than a sword...
Reply 14 years ago on Introduction
i dont see how it looks like a pooper scooper but that would be funny
Reply 14 years ago on Introduction
LoL
14 years ago on Introduction
meh, it can be easily snapped, and it uses too many exotic parts. 3.5*
Reply 14 years ago on Introduction
Exotic parts?
Reply 14 years ago on Introduction
those things in the middle
Reply 14 years ago on Introduction
The panels?
Reply 14 years ago on Introduction
yeah.
Reply 14 years ago on Introduction
I have way to many of them O.o I don't remember that last time I used one either.
14 years ago on Introduction
its ok........... but look around the site before you post things like this but for your first i give you 3 1/2*s!
Reply 14 years ago on Introduction
I did but most were flat or complicated
Reply 14 years ago on Introduction
Oh that's okay. We need more knexers and instructables that are good. Keep trying!
Reply 14 years ago on Introduction
this was also my first knex weapon I ever made without instructions
Reply 14 years ago on Introduction
Yeah, the sword is pretty good!
14 years ago on Introduction
omg handle!
14 years ago on Introduction
Its okay..
14 years ago on Introduction
this is my first Instructable