home made graphene powder?

How can i make graphene for cheap and isolate it i try adesive tap but hoe to get graphene out of it i want to make a ultra capacitor

Question by mihir.sahu.355   |  last reply


Where can I get reinforced graphene to make bullet proof aromor? Answered

Where can I get reinforced graphene for bullet proof armor? I live in McAllen Texas. I'm trying to get a type of graphene that is stronger than steel, but I'm not sure if I'm suppose to get reinforced graphene plastic or some other type, don't even know the names and differentions.

Question by Anti11   |  last reply


Where to get this body armor design made or how to make it?

I have a design for original body armor, but I don't know where to buy it or get it built. Think of a nomex survival suit, but Dragon Skin and Kevlar for fabric covering underneath armor, 2nd layer U.S.A. brand or Japanese exoskeleton suit with titanium caseing, 3rd layer graphene and dragon skin for plates covering entire body like a full body mold but cut in pieces for flexibility. Where can I get this built or how can I build it precisely. It will last against a FN FAL. I live in McAllen Texas. I prefer professionally made, so any suggestions. I have no budget.

Question by Anti11   |  last reply


Charge AND balance 4 Lipo packs? Series Parallel solution help.

I have x4 identical Turnigy Graphene Professional 5200mAh 3S2P 15C LiPo Packs w/XT60 - and I need 22.2v out of them for a portable boombox project.   I have x2 12S 30A BMS's to balance / charge on board and a 600w 48v 12.5 A power supply. By wiring up the battery packs in series then parallel to get the 22.2v output - if I then connected the BMS (either by directly wiring to each cell or using the pack balance plugs) would it would cause a short circuit through the balance wires?    The ideal solution would be a wall plug power supply that plugs into the (sealed) boombox and charges all of the batteries through the BMS's. Is there any way of achieving this through parallel charging (not a fan) or could I switch easily between the two wiring set ups?   I'm trying to avoid buying a £200 Lipo charger and connect the batteries directly or keep disassembling the boombox every time it needs charging. Thanks

Question by MechaMatt   |  last reply