Casting Resin issue? Answered
I'm trying to cast some resin claws for a halloween/convention costume I'm trying to make ( it isn't a Wolverine one .. more a VERY twisted, evil, and blood thirsty Mad Hatter character ) and running into a bit of trouble. I'm following the 5 drops of hardener per 1 oz of resin that is stated on the resin can's instructions. It also says it's supposed to set hard enough to support objects at 40 minutes. I mixed a 2oz batch of resin ( 10 drops of hardener ) and poured it into a rubber latex lined plaster mold that I had sprayed with mold release. I put a bolt down partly into the resin so I can later attach a wire to it and left it alone for about an hour to an hour and a half. I came back to check on it and the bolt was still able to be moved/removed with NO resistance. I figured the mix was bad and threw it out, but noticed it was the consistancy of slime. Did I mess it up and not wait long enough, or did I not add enough hardener or what ? Any suggestions would be great!