Search for 4Ohm resistor in Topics


Speaker resistance?

I have an amp schematics and for the speaker rezistance it says 8 ohms. I have 4 ohm speakers so I am worried that amp circuit will burn. Will it be ok, or should I put a 4ohm resistor in series with the speaker. The chip is TDA2615. Power source is 12v lead-acid battery.

Question by Dantex    |  last reply


Tesla coil configuration. Audio amplifier power supply?

If I am to use an audio amplifier as a power supply for a Tesla coil could I do without a spark gap and primary capacitor? I will be operating the coil within the audible spectrum (1Hz - 20KHz) so an amplifier fits the bill. It's a 2 channel magnetic field power amplifier rated for 750W per channel. That's 750RMS not 750IFL. (If lightning strikes) The current would flow as follows: Power Amp> 4ohm Load> NST 5000v 60ma> RF Choke> Primary Coil> Secondary Coil 1. Do I need a capacitor bank between the RFC and the primary? 2. Can a few feet of 28AWG galvanized steel wire act as a reliable resistor for the 300W current? What about 750W? If not, what can I substitute? 3. Can the amp hold together? I need it in one piece. Please point out the flaws. Thank you

Question by imMrDude