How do you remove and install the clock in a 1999 Camry?

Hello, I have a 1999 Camry XLE with a in dash clock that needs replaced. I would like to know how to do that. Thank you,

Question by dsocar   |  last reply


Can you put a 13b Wankel Rotary in a Corolla or Camry? Answered

13b wankel rotary engine. 89 Corolla 87 Camry.

Question by Yerboogieman   |  last reply


1990 Camry front signal cover release?

How do I get the front turn signal cover off to replace the signal bulb?  I unscrewed the screws I could see outside and pulled.... which got one end loose, but that's all. Screwed it back together... and have been driving around right front blinker-less since. Not good.

Question by mole1   |  last reply


lift kit, or stronger springs?

98 toyota camry. lotsa tools in trunk. sometimes a trailer, or bike rack. back end tends to bottom out. just replaced struts. improvement. but still bottoms out some. suggestions?

Topic by Toga_Dan   |  last reply


Help me diagnose a check engine light for a patch and my eternal esteem! Answered

Check Engine Light/ Catalytic Converter: A while ago my 97 V6 XLE Camry's check engine light went on and the guys at the dealership who ripped me off to diagnose it ($100) explained that it was a bad catcon. I replaced the part (with much sweat blood and tears) and it solved the problem (light went off) and the vehicle passed emissions testing. Whohoo! Only now the light is back on and I am not savvy enough to just figure it out and not rich enough to buy the diagnostic testing device or to take it back to the dealer. Anyone know of a good way to diagnose for cheap?! 

Question by Kaelessin   |  last reply


Pros and cons car for camping. Suburban, truck, or wagon

I have a 3 door 1971 suburban Custom. 350 small block i think Edelbrock headers (if anyone knows where to get a gasket that drops in, let me know. (-;) Edelbrock 4 barrel carb Posi rear end detroit lockers LSD front Barn door rear doors. And my brothers 91 ford ranger 4 cyl. 4 speed with overdrive RWD 2 1/2 seater no canopy An 87 camry wagon. FWD 4 cyl knocking engine. new clutch All of them have custom LOUD stereo's. There are 3 or 4 people going. Don't turn this into a ford vs chevy vs Toyota debate

Question by Yerboogieman   |  last reply


Homemade Car IR Night Vision ?

I am a retired guy with less than perfect night vision. I have installed a LED Backup camera and portable display in my Camry and wonder how hard it would be to do the same only looking foreward. Ebay has a lot of IR cameras that include IR Light LEDs. Shouldn't I be able to connect one to my monitor to get some extra driving safety? Of course, everything is possible to the guy who doesn't know how to do it! Thanks in advance.. Here is an article from a BMW site I think............. "...In 2000, General Motors offered a thermal night-vision system in its Cadillac line of vehicles. The system was innovative, but it was also expensive and didn't produce very clear images. Toyota also gave night vision a shot, and even now the automaker continues to offer an in-dash system in some Lexus models. The Lexus system has its fans, but if it's so effective, then why hasn't this technology spread to every vehicle on the road? One theory is that it seems as if the technology just isn't fully ready for automotive applications. Not yet, anyway. As you can imagine, night-vision technology is expensive and if you use inexpensive components, the quality simply won't be there.  Two of Germany's automotive stalwarts, BMW and Mercedes-Benz, have taken a damn-the-torpedoes approach to in-dash night-vision systems. These two auto manufacturers have been offering night-vision systems in vehicles since 2006..."

Question by R.Snare   |  last reply