Hey y'all, I was bored, so I made this RC hovercraft, kinda like a Tiny Whoov, from the guts of a $5 RC helicopter (sold at most FiveBelows). The idea is that a hovercraft is more fun than a cruddy helicopter, in addition to being a fun and easy DIY project for the weekend. It could be a nice gift to a kid. My first concern was that the motors would not provide enough power to get the thing moving. They give more than enough power, and this thing can MOVE. My second concern is that the differential thrust steering system (one motor turns faster than the other, steering the hovercraft) would not be effective enough. This is still a problem that I don't have the enthusiasm or time to solve anymore. Maybe someone could figure out how to reprogram the FC board to have more differential thrust (is that possible?), or somehow configure a servo or actuator without raising the cost of materials too much. Anyway, here's the concept, go have fun with it.Supplies:Foam platesHot glue$5 RC helicopter with 2 motors and receiver (LED optional, but really cool)Connector (the battery might be soldered directly to the FC board, so this will make it easier to fiddle with)Soldering iron (not %100 necessary, but it can come in handy)Propellers (see design notes)Design notes:Notice how the underside of the hull is curved and smooth. I used propellers from a Blade Inductrix FPV Pro, but any micro quad propellers should work. Notice the nice little compartment under the FC board where you can stick a battery without the need for Velcro or glue. This would be a very easy FPV mod, but that would add about $20 to the cost.